| Last Modified: 11-29-2007 | 1.6 J | |
| Service Category: Audio/Visual/Telematics | Section: Audio/Video | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM0000033VX003X |
| Title: AUDIO / VIDEO: REAR SEAT ENTERTAINMENT SYSTEM: DESCRIPTION (2008 Sequoia) | ||
|
Sound Signal Circuit between Navigation Receiver Assembly and Television Display Assembly |
DESCRIPTION
This circuit sends a sound signal from the television display assembly to the navigation receiver assembly.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - NAVIGATION RECEIVER ASSEMBLY) |
|
(a) Disconnect the U2 television display assembly connector. |
(b) Disconnect the I25 navigation receiver assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
I25-2 (CDR+) - U2-28 (R+) |
Always |
Below 1 Ω |
|
I25-3 (CDR-) - U2-29 (R-) |
||
|
I25-4 (CDL+) - U2-30 (L+) |
||
|
I25-5 (CDL-) U2-31 (L-) |
||
|
I25-1 (CSLD) - U2-27 (SLD9) |
||
|
I25-2 (CDR+) - Body ground |
Always |
10 kΩ or higher |
|
I25-3 (CDR-) - Body ground |
||
|
I25-4 (CDL+) - Body ground |
||
|
I25-5 (CDL-) Body ground |
||
|
I25-1 (CSLD) - Body ground |
(d) Reconnect the television display assembly connector.
(e) Reconnect the navigation receiver assembly connector.
|
|
2. |
INSPECT TELEVISION DISPLAY ASSEMBLY |
|
(a) Using an oscilloscope, check the waveform between each terminal and the body ground according to the conditions, as shown in the table below. OK: Waveform:
|
|
|
|